Big Bear 350 starting problems.?

2015-12-08 9:14 pm
My big bear 350 when you hit the electric start it just ave to use the rolls it does not start unless the engine is warm then the electric start works so in order to get it going you have to use the pullcord but it worked before so i need help.

回答 (3)

2015-12-08 11:05 pm
✔ 最佳答案
It has gas and oil like its supposed to?

Cranks but wont start
when trying electric start
it will start
But has to be warm.........we'll call that hard starting.
but could be connective issue.

hard starting when cold.
cranks and cranks. with electric start.
You have to start with the pull cord

Does it have a "run" or "on" switch? or a kill switch problem?

Like a rider mower, you have to sit in the seat and depress the switch
with your weight? that can b a safety circuit? not sure what exactly it has. or the year

Then is the fuel turned partly off?
or the choking system has an issue

Warm engines start without choke.
pulling the cord for 10 minutes kinda warms them up.
and killswitches or the keyswitch can be loose from vibration
or have connection issue or just chincy parts sometimes in miniature.

Hope some of this helps. and its not modified, if so, ask

Clean and gap your spark plug and or ignitor gap for weak spark issue.
The spark would tick and be less frequent instead of going snap.
You ground the plug electrode and pull the cord, observe removed
cleaned gapped plug connected

GOOGLE (bigbear 350 hard to start cold)

several discussions about that are there,
you might clarify and define your symptom better before replacing parts, clean connections, make tight connections
and improve spark or cranking power, or read about
fuel issue, see what you find.
Many pull start ignitors I have checked had oxidation or rust,
and I gap them upon install with a business card
That makes a visible difference in how the spark jumps on the plug.
I flush the carbon from the cylinder if I can tilt the machine to drain the carb spray out while pulling the rope.
2015-12-08 10:02 pm
sorry i mean when you hit the electric start it just turns over. it wont start and theres compression in the engine
and its not the solenoid
2015-12-08 9:38 pm
"you hit the electric start it just ave to use the rolls" I do not know what that means. It could be the solenoid.


收錄日期: 2021-04-21 15:37:23
原文連結 [永久失效]:
https://hk.answers.yahoo.com/question/index?qid=20151208131442AAiWXG1

檢視 Wayback Machine 備份