-----------------------------------------------------------------------------------
1.1Upon First Use of the Computer System
It is recommended that you save a copy of the original motherboard BIOS along with a
Flash Memory Writer utility (AFLASH.EXE) to a bootable floppy disk in case you need
to reinstall the BIOS later. AFLASH.EXE is a Flash Memory Writer utility that updates
the BIOS by uploading a new BIOS file to the programmable flash ROM on the motherboard.
This file works only in DOS mode. To determine the BIOS version of your motherboard,
check the last four numbers of the code displayed on the upper left-hand corner of your
screen during bootup. Larger numbers represent a newer BIOS file.
1. Type FORMAT A:/S at the DOS prompt to create a bootable system floppy disk.
DO NOT copy AUTOEXEC.BAT & CONFIG.SYS to the disk.
2. Type COPY D:\AFLASH\AFLASH.EXE A:\ (assuming D is your CD-ROM drive) to copy
AFLASH.EXE to the just created boot disk.
NOTE: AFLASH works only in DOS mode. It will not work with DOS prompt in Windows and will
not work with certain memory drivers that may be loaded when you boot from your hard
drive. It is recommended that you reboot using a floppy.
3. Reboot your computer from the floppy disk.
NOTE: BIOS setup must specify floppy?as the first item in the boot sequence.
4. In DOS mode, type A:\AFLASH <Enter> to run AFLASH.
5. Select 1. Save Current BIOS to File from the Main menu and press <Enter>.
The Save Current BIOS To File screen appears.
6. Type a filename and the path, for example, A:\XXX-XX.XXX and then press
由於字數限制，所以我會在補充內容繼續…
1.2Updating BIOS Procedures 1. Download an updated ASUS BIOS file from the Internet (WWW or FTP) (see ASUS CONTACT INFORMATION on User Ma for details) and save to the disk you created earlier. 2. Boot from the disk you created earlier.
3. At the A:\ prompt, type AFLASH and then press . 4. At the Main Menu, type 2 and then press . The Update BIOS Including Boot Block and ESCD screen appears.
5. Type the filename of your new BIOS and the path, for example, A:\XXX-XX.XXX, and then press . NOTE: To cancel this operation, press . 6. When prompted to confirm the BIOS update, press Y to start the update.
7. The utility starts to program the new BIOS information into the flash ROM. The boot block will be updated automatically only when necessary.
updated automatically only when necessary. This will minimize the chance that a failed update will prevent your system from booting up. When the programming is finished, Flashed Successfully will be displayed.
NOTE: When you see the message "Boot Block is different" you may still press to update the BIOS. Yet if the update fails, your system will run a greater risk of boot failure depending on whether the boot block is damaged or not. 8. Follow the onscreen instructions to continue.
''1.為了製作「戰利品-可能」''' 你係咪用yahoo translate嫁… 唉~
